Compact & Precision Pneumatic Die Cutter with A Pair Die for Pouch Battery Research - MSK-180SP

Standard Cutting Die Dimension

• Cathode Die: 56mm (L) x 43mm (W). With 14mm (L) x 11mm (W) protrude current collector.
• Anode Die: 58mm (L) x 45mm (W). With 13mm (L) x 11mm (W) protrude current collector
• The standard cutting die for replacement can be found here: M180SP5643
• 
• Customized dies with Max. dimension 120mm L x 80mm W, including current collector, available at extra cost. Please indicates the customized electrode dimension of A,B,C,D, E in the following diagram.

• If used for Li metal foil cutting, a customized cutting die with special blades (surface coated with silicon) should be considered. 

• Use the plate pad to hold the electrode and minimize permanent markings on the base.
• 
    Warning: please don't use other material to replace the pad

• KF40 Feedthrough with all necessary wire and tube are included to allow operating inside the Glovebox, which has a KF40 port (Click on the picture for details)
• Please use Inert gas when operating in the glove box.
• One KF-40 clamp with rubber O-ring is included

• 0.5~1.0Mpa (0.7Mpa is recommended)
• To use inside the glove box, please use compressed inert gas such as Ar
• To use outside the glove box, you may use the air compressor, 60 psi recommended
• Compressor is not included, please click the image below to order
• Attention: If a gas cylinder is used instead of an air compressor(pic2), a two-stage pressure regulator(pic1) must be installed on the gas cylinder to limit the pressure within the required working range for safe operation. Click here to learn the installation of a gas regulator
  

       

• CE Certified
• No UL required because of no electricity
  

• You may order a pre-formed pouch cell case and other accessories  by click the picture below right
• You might order a round cutting die kit to cut coin cell electrodes and separator by click the picture below
• Please consider a 3 in1 sealing machine to make pouch cell

• A perfect fit for the cases formed by the standard size MSK-120, with no rough edge, clippings, or creasings
• The shape of the electrodes it produces is also handy for the later processing steps such as tab welding by MSK-800 and electrode stacking by MSK-111A
  
• Compact design enables the operation inside the glove box with Ar atmosphere where Lithium Sulfur, Lithium Air, Lithium Solid State or Li-ion half cell will be assembled. Please click the images in below to understand these technologies and how it fits in a glove box